How can I change a stick's invertedness in a shift mode?
I noticed that an inverted stick in unshifted mode will also be inverted in a shifted mode without any way to change one without changing the other. For example, I can't have my unshifted right stick set to normal and have my shifted right stick set to inverted, it's either one or the other but not both. Is there any way around this without having Pinnacle load an entire other profile rather than using a shift mode?
there is currently no way to change the inverted state in a shift-mode, you would have to use a hotswap.
If I used a hot swap, is there a way to save both profiles into one profile?
Hmmm... well, for terminology's sake, this is how it works.
a Profile consists of Commands and Configurations , and Commands consist of event steps.
The 'hotswap' is a 'configuration HOTSWAP' event step that goes inside some command that you then assign to your configurations
So if the only thing you wanted to change was the inverted state, you would create a configuration, then right-click on it in the list and select 'duplicate configuration' then change the invert state with the Joystick Setup button. Create a command to hotswap from one config to the other, and that's it.
This thread is old, but it explains the concept of a 'hotswap shift button' perfectly...